With Love Gift Box

Cut a white A4 cardstock in half to make two A5 size pieces. Score the first A5 cardstock from each edge at 1” (turn and score until all sides are scored), this will be your lid.

Repeat with the second A5 cardstock, but this time score at 1 1⁄8”, this will be the bottom (you can mark it as such on the inside with a pencil).

Measure the centre of the lid and cut a green card ¼” smaller than the centre, then adhere the green panel onto the lid piece.

Line up and die-cut three squares in the centre using the smallest square die from the Tonic Studios Layering Squares die set. Die-cut the three smallest white frames and back them with the vellum paper, then adhere them in place to cover the die-cut square holes.

Make a small cut along the previously scored lines in the corners of both A5 pieces to make the folding flaps, cut a little notch out next to each cut line so that the flap fold inside nicely and then assemble both the lid and the base.

Apply the embossing ink to the dies placed on the cutting plate, cover them with a white cardstock and run it through the machine. Sprinkle the embossing powder over the flower die-cuts and heat set the Blush Pearl powder. Repeat with the Glitter powder on the leaves.

Assemble the flower, wrap the twine around the box and tie a bow. Adhere the flower and add further detail in the centre using the Nuvo Drops.