With all my love- polka dot sentiment panel

Cut the backing plate of the sentiment die from Gleaming Lilac cardstock, and the sentiment from Bright White cardstock then adhere the sentiment to the backing plate. Die-cut another sentiment from Golden Mosaic cardstock and paper piece the offcuts back into the sentiment. Cut a 1.1x6.5cm piece of white cardstock, round the corners using a punch and use 3D foam pads to add the topper as shown.

Cut two 0.5x5cm strips of acetate, fold at 1cm then add high-tack tape to the folded section. Adhere to the reverse of the topper, 2cm from each end. Cut two 1.1x6.5cm pieces of white cardstock, round the corners and add one to the reverse of the topper, leaving the long pieces of acetate exposed at the top. Secure high-tack tape to the front of the long acetate strips and adhere to the reverse of the other white panel to create a small hinged card as shown.

Print a selection of patterned paper and trim to 1.6x10.5cm then adhere to the card blank. Add the hinged card to the centre of the card front as shown to finish.