Very Happy Birthday Emerald Foiled Card

Tape the stencil in place onto a piece of yellow Centura Pearl cardstock and use a palette knife to apply the transfer gel. Carefully remove the stencil and leave aside to dry.

Add a little transfer gel onto an acrylic block and use a sponge to dab the gel onto the sentiment stamp. Stamp onto a piece of light blue cardstock and leave to dry.

Once the gel is dry on both pieces take a piece of folded paper, the stamped cardstock and a piece of foil transfer sheet with the coloured-side up and place inside a card shim. Run through the hot laminator and peel away the transfer sheet.

Trim the edges of the stencilled panel then cut into four pieces, the largest measuring 9.5cm-square. Position the pieces onto a square of white cardstock leaving narrow gaps in between and adhere. Wrap yellow ribbon around as shown, layer the panel onto blue cardstock then attach to the card front.

Mat the sentiment onto dark blue cardstock and attach to the card front using 3D foam pads. Tie on two pieces of ribbon where the ribbon crosses to finish.