Thank You Chandra Stem Foiled Card

Cut a 13x18cm piece of white cardstock and die-cut one flower stem on the right-hand side. Die-cut a second flower stem with the stem crossing over the first die-cut at the base of the card to make the stencil.

Spray the back of the card stencil with repositionable adhesive spray and place onto white cardstock which is larger than the stencil. Make sure all areas of the stencil are adhered to the card and use the palette knife to spread Transfer Gel through the stencil. Spread the gel as flat as possible and return any excess to the pot. Carefully remove the stencil and check to see if the gel has any small bubbles. Pop any bubbles with a pin and set aside to dry.

Cut a piece of foil to size and make sure the laminator is hot. Fold a piece of parchment in half and place the cardstock with Transfer Gel facing up and the foil on top with coloured side up. Fold the parchment over the foil and feed into the laminator folded edge first. Allow to cool slightly and remove the foil sheet.

Trim the panel to 11.5x16.5cm. Use Onyx Black ink to stamp the sentiment in the bottom corner then matt onto turquoise card. Attach to the card front using 3D foam pads and add gems to finish.