Sweet Christmas Slider Card

Cut a 9.5x14.5cm piece of white cardstock and use a pencil to mark 1.3cm in on every corner of every side. Draw a line joining up the opposite sides then a smaller line on the other sides.

Cut out the rectangle sections on the shortest ends and wrap a 26x6.5cm piece of soft plastic such as a sandwich bag around it. Adhere together using a strip of double-sided tape – be sure not to have any tape stuck to the cardstock.

Add a strip of double-sided tape over the join of the plastic and slide towards the left-hand side. Flip this over then add another strip of double-sided tape to the right-hand side.

Cut two 15x6.5cm pieces of white cardstock and adhere each one to the strips of double-sided tape. Decorate both panels with 13x6cm pieces of patterned paper as shown.

Add double-sided foam tabs to the top and bottom of both sides of the mechanism piece. Cut two 15.5x10.5cm pieces of purple cardstock and adhere one on each side of the mechanism, so it’s sandwiched between the two pieces.

Cut a 17x11cm piece of purple cardstock for the stand. Score the long side at 6cm, 12cm, 14cm and 16cm. Fold and assemble in the same way as is shown on the advanced design.

Decorate the front of the panels as shown to finish.