1

Trim white cardstock the same size as the paper pad, then score at a third and two-thirds along the length, then rotate 90º and score both lines again. Diagonally score the four corner squares from the corners to the centre as shown.

2

Die-cut 14 gold 10cm squares and 14 star design 9.5cm squares. Cut four of each of the squares in half diagonally, then matt and layer star paper onto gold Mirri and adhere to the inside and outside sides. Adhere only the diagonal ones to the inside corner squares, keeping one of each for the box lid.

3

Die-cut two large stars from gold Mirri, four medium stars from gold Mirri, three medium stars from white cardstock, four small stars from white cardstock and one small star from gold Mirri.

4

Emboss the small and medium stars with Shimmering Stars embossing folder. Layer the stars and adhere to the inside sides as shown, saving some for the box lid.

5

Die-cut two each of the sentiment letters from gold Mirri and adhere to the diagonal corners as shown.

6

Trim 16.2cm square of white cardstock and score at 3cm on each side. Matt and layer Mirri card and star paper to the top and sides. Adhere a couple of the layered stars to the top using 3D foam pads.