Sequin Panel Party Invitation

Set the size of the Special Day digi stamp to measure 12cm high then print onto white cardstock and colour with Copic markers. Cut out, leaving a narrow border.

To create the ‘Polaroid’ shaker panel, die-cut a 12x9cm rectangle from white cardstock then position a 7.5cm square die at the top and die-cut an aperture. Adhere acetate behind the aperture. Add 3D foam tape around the aperture leaving no gaps and add a strip across the bottom of the square aperture.

Cover an 11.5x8.5cm piece of white cardstock with yellow leaves design paper, add sequins and adhere behind the ‘Polaroid’ panel.

Matt and layer a 14x10cm piece of purple patterned design paper onto purple pearlescent cardstock leaving a narrow border. Adhere this panel to the card blank.

Adhere the ‘Polaroid’ shaker panel to the card front.

Affix the image to the bottom left of the shaker panel.

Finish with a printed and die-cut Let’s Party sentiment to the bottom right of the panel.