Reindeer Stamped Christmas Card

Cut a 15x9.5cm piece of white cardstock. Press a little Candied Apple Distress Oxide Ink onto a craft mat and spritz with water, pick up the ink with a piece of acetate and transfer onto the panel. Repeat this process with Evergreen Bough and Wilted Violet Distress Oxide and leave to dry.

Place the star stencil over the panel and spread a little glimmer paste randomly across then leave to dry.

Take a piece of white cardstock and press Walnut Stain Distress Oxide onto the craft mat. Spritz with water then dip the panel onto the ink, dry using a heat tool and continue dipping and drying until the desired coverage is achieved.

Stamp the deer three times onto the Walnut Stain panel, leaving enough space to die-cut each, then adhere them to the inked panel using 3D foam pads. Attach the panel to the card front.

Use Jet Black ink to stamp the sentiment onto vellum then heat-emboss using clear powder. Tear the vellum to get a rough edge and fold one side around the card edge to adhere, add a little glue under ‘friend’ so it lies flat.

Cut two narrow strips of white cardstock the length of the card front, colour using Evergreen Bough Distress Oxide and adhere above and below the centre panel.

Colour the centre deer’s nose and add Ranger Glossy Accents to all of the noses to finish.