Red And Orange Heart Card To say Hello

Cut a 23x15cm piece of raspberry cardstock then score along the longer edge at 5cm, 7cm, 16cm and 18cm. Fold and burnish the score lines to make two opposite Z shapes.

Cut two pieces of patterned paper 4.7x14.5cm and attach to the end panels as shown, then trim a 8.8x14.5cm piece and attach to the central panel.

Make a pencil mark 1.5cm from the top on the first score line and 1.5cm from the bottom on the last score line. Place the top of the die at the upper pencil mark and the centre of the die along the score line and hold in place with low-tack tape.

To partially die-cut the card, place the top cutting plate up to the score line and pass through the die-cutting machine.

Place the bottom of the heart die at the lower pencil mark and the centre of the die along the score line and hold in place with low-tack tape. Partially die-cut again by placing the top cutting plate up to the score line.

Die-cut four hearts using the same die from orange cardstock and attach to each side of the partial die-cut.