One Big Adventure Birthday Card

Attach a 14cm square of yellow cardstock to the card front. Emboss a 12cm square of blue cardstock and cut around the hills and balloon to trim the bottom section of the design. Snip into the sunrays from the outside edges up to the clouds then adhere the panel near to the top of the card front as shown.

Emboss a 12cm-square piece of green cardstock and cut off the sky section as shown.

Attach both elements to the card front, lining up the edge of the hills with the blue sky section.

Place white cardstock inside the embossing folder to cover the clouds, emboss and cut out the clouds then layer onto the blue section using 3D foam pads. Place red cardstock over the hot air balloon inside the embossing folder, emboss and cut out then secure onto the green section using 3D foam pads. Repeat with yellow cardstock and leave aside.

Attach a 13cm square of white cardstock onto a slightly larger piece of blue cardstock and die-cut a large circle aperture from the centre. Adhere the panel to the card blank using 3D foam pads.

Stamp the compass onto a small circle of blue cardstock. Stamp again onto yellow cardstock, cut out the centre section and attach to the blue compass then secure to the card front along with the yellow hot air balloon. Stamp the sentiment and trim into three sections, layer onto blue cardstock leaving a narrow border and attach as shown to finish.