New baby swan card

Pop out the swimming swan découpage and assemble all but the base layer using 3D foam pads.

Use the stitched border die to cut an extra hillside from turquoise cardstock and position behind the swan as shown.

Cut a square of swan patterned paper to the width of the découpage and affix the swan panel over it using 3D foam pads. Matt and layer onto white and turquoise cardstock leaving narrow borders then affix to the card front.

Die-cut the greeting from pink glitter and white cardstock, snip the bricks from the white die-cut and assemble using the letters from the pink die-cut to co-ordinate.

Die-cut a stitched square and matt onto white cardstock, add the greeting and affix to the card front using 3D foam pads. Add a bow and a few pearls in the top-right corner to finish.