Love Panel Card

Cut a piece of Crumb Cake cardstock to create a 4¼x5½” card blank. Cut another piece of Crumb Cake card slightly smaller than the card front, emboss using the brick folder and ink the edges.

Tie a length of ribbon around the embossed panel, securing in a knot on the left-hand side. Cut a smaller panel of designer paper and stamp texture onto it using Soft Suede and Berry Burst.

Stamp the frame with Soft Suede ink on Whisper White cardstock three times and then stamp the “LOVE’ sentiment inside with Berry Burst ink and punch into a label before mounting onto the card front using 3D foam pads.

For the inside, cut a 71/2x4” piece of Whisper White cardstock and score and fold in half along the longest edge. Using a precision knife, cut two slits side by side at the centre of the fold vertically approximately ½” apart and ¾” tall either side of the fold.

Stamp the sentiment and speckles using Berry Burst ink, die-cut a small row of hearts at the bottom of the panel.

Pull out the slits to create the pop-up tab and glue the white cardstock to the inside of the card, do not add glue to the pop-up tab.

Die-cut a large heart from co-ordinating paper and stamp the sentiment with VersaMark ink, sprinkle with white embossing powder and heat-emboss. Glue the bottom of the heart to the pop-up tab to finish.