Live now in this precious moment - a quick and easy card of encouragement

Die-cut a circle from masking paper, big enough to cover the sentiment.

Add the mask to the centre of a 6” square of cardstock, then stamp the image, following the instructions on the pack and the Step-by-step guide below from step 6.

Remove the mask and using the largest circle die, die cut a circle from the stamped image.

Trim one edge of the die cut circle to fit against the edge of the card blank.

Stamp a sentiment in to the previously masked area, and affix the panel to the card blank..

Create the design by taping the 6” square background plate to the stamping press, position the stamp on the lid so that it sits perfectly on top, lift off the lid and use magnets to secure a 6” square of cardstock. Ink up the stamp on the lid, covering it completely.

Press the stamp on the cardstock, applying even pressure all over. Lift the cardstock and rotate 90 degrees before placing it back down in the same position. Secure with magnets again. Ink up the stamp and close the stamping press again, pressing down to get a second layer.

Rotate the cardstock again, ink up the stamp and press a third time, adding even more detail to the cardstock panel. Rotate until the panel is complete.