1

Trim another pink pearlescent panel to measure 33/4 x53/4” then matt and layer with floral design paper leaving a narrow border – this will be the slider insert.

2

Place the insert inside the pocket and punch a hole in the centre approximately ¾” down from the open pocket end. Remove the insert piece and flip it so that the punched hole is on the left, then replace in the pocket and match up the punched holes.

3

Thread a ribbon through the holes and wrap around the insert, tying a bow at the right of the insert. This will allow the insert to slide in and out without coming out completely.

4

Adhere floral design paper to the front of the pocket card base, making sure not to add adhesive over the punched hole and ribbon.

5

Add a border of co-ordinating design paper to the left, then die-cut the solid butterfly from pink pearlescent card and the filigree butterfly from floral design paper.

6

Stamp the sentiment, matt and layer and adhere onto the card front, then add punched butterflies and finish with pearls.