Hi- purple floral telescopic circle aperture card

Trim a 12cm-square of pearlescent card and two 12cm-squares of co-ordinating patterned papers, then die-cut the largest Circle STAX die from the bottom-right corner of the pearlescent card. Die-cut the die two sizes down from the STAX set from the bottomright corner of the dotty design paper, then die-cut the die two sizes down again from the bottom right of the floral design paper.

Emboss the pearlescent card after the circle has been die-cut to stop the embossing being flattened, then die-cut the largest frame from white cardstock and adhere over the aperture on the pearlescent card as shown.

Adhere the layers onto top of each other using 3D foam tape between each layer and starting with the smaller die-cut circle at the bottom, adhered directly to the card front.

Die-cut the ‘hi’ sentiment from lilac pearlescent card and adhere to the inside of the small circle aperture. Finish with a pearl as the dot, on the ‘i’.