'Hello' Star Die Cut Card

Apply Distress Oxide Ink to a panel of white cardstock measuring the same as the card front, back it with a foam sheet and die-cut enough stars from it to cover a 5”-square card blank.

Arrange the stars on top of the panel and lift them all up with the transfer sheet. Place this onto your cutting plate and secure the circle die in the centre using 3D foam tape, then die-cut.

Remove the centre circle die-cut piece, place the remaining frame upside down on your craft mat, add glue to each die-cut, lift the sheet and place over the card front.

Trim around the edges to avoid overhanging edges and add a die-cut sentiment as shown along with a few sequins to finish.