Hello- scalloped panel glittery shaker card

Cut the largest outer edge die from white cardstock. Cut an aperture into the white die-cut using the smallest frame die. Add acetate to the reverse of the frame using high-tack tape. Add 3D foam pads around the edge to create a well for the sequins then add sequins inside the 3D foam pads. Secure a piece of white cardstock to the 3D foam pads to create a shaker.

Cut two 5x0.5cm strips of acetate. Fold at 1cm and add high-tack tape to the folded section, then adhere to the reverse of the shaker. Die-cut two of the largest die from white cardstock and add one to the reverse of the shaker, leaving the long pieces of acetate exposed at the top. Apply high-tack tape to the front of the long acetate strips and adhere to the reverse of the other white panel to create a small hinged topper.

Print a selection of patterned paper, trim to 12.7x10.2cm then layer onto a 13x10.5cm piece of Golden Mosaic cardstock. Attach both to the card blank then secure the hinged topper to the centre of the card front as shown.

Die-cut the sentiment from Golden Mosaic cardstock and attach as shown to finish.