1

Matt a red 14.5cm-square panel using 3D foam pads, then matt a blue 14cm-square panel onto it.

2

Adhere a red 13.5cm-square matt onto the card front at an angle using 3D foam tape as shown, then die-cut a blue teapot.

3

Die-cut the lace detail die from white cardstock and spray one side with spray glue, then add glitter. Spray the reverse side and add to the blue teapot die-cut.

4

Add the completed teapot onto the card front using silicone glue, then add a red ‘party’ die-cut, affixing pearls as shown to finish.