1

Place a large circle die to slightly overlap the folded edge of the card blank and cut out. Cut the same die from white cardstock and attach. Trim 0.5cm from the bottom so the card base will stand upright.

2

Attach a slightly smaller pink scalloped circle to the card front.

3

Die-cut a smaller circle from white cardstock. Place inside the stamping platform and stamp the wishing well image in the centre of the circle. Remove the circle from the stamping platform. Colour using Copic markers and attach to the centre of the card front.

4

Die-cut a smaller scalloped circle from green polka dot paper. Layer onto a slightly larger white circle. Place inside the stamping platform and stamp the wishing well in the centre.

5

Die-cut the image from the circle using the co-ordinating die. Place onto a circle of white craft foam and mark inside the aperture with pencil. Use the pencil marks as a guide to cut an aperture from the foam then adhere the aperture panel on top. Attach to the card front.

6

Stamp ‘Wishing’ onto white cardstock, cut out using the co-ordinating die and attach to the top-left corner of the card front using 3D foam pads. Stamp ‘you happiness forever’ onto white cardstock, trim and attach at the bottom of the card base using 3D foam pads to finish.