From Me To You tag

Pre-heat the Glimmer machine, place the dies in the centre with the cut side upwards, place the foil on top (shiny side down), place the red cardstock on top, cover it with the plates and run it through your die-cutting machine.

Move the dies onto the regular die-cutting plates without the foil (make sure they are line up to the design, use Washi tape to keep them in place) and run it through the machine again to die-cut the foiled pieces.

Remove any unwanted foiled areas with a rubber eraser. Cut the white cardstock to 3x4” and the green to 2¾x3¾”.

Round the two top corners, adhere them together, punch the hole and adhere the diecuts to the bottom section of the tag. Stamp and adhere the sentiment and tie the twine.