Floral Inspire Me Slider Card

Stamp a floral image into the centre of a white die-cut pierced circle and colour using markers. Layer onto a larger pink circle, then onto a white scalloped circle. Stamp the same image onto white cardstock, colour the flowers, cut out and layer onto the main image using 3D foam pads.

Attach a 13.5x10.5cm piece of pink patterned paper onto a 13.5cm square of green cardstock. Layer onto a 14cm square of pink cardstock and turn over. Place the sliding element into the centre of the panel, mark with a pencil along the left-hand side of the element and mark 0.5cm in from each end of the right-hand side.

Remove the sliding element and draw lines from the left-hand pencil mark up to the marks at each side, stopping 1.5cm from the right-hand side of the panel. Cut along the lines then erase the pencil marks.

Cut a 1.5x11cm piece of acetate. Attach to the reverse of the sliding panel so it is 3cm from the left-hand side, ensuring the tape is over 0.5cm from each side of the panel. Turn the panel back over and slot the sides of the acetate into the slits. Use tape to hold the element in place temporarily.

Turn the panel over and place double-sided tape, with the adhesive facing upwards, under the acetate, right up to the sides of the sliding element. Press the acetate onto the tape at each side.

Cut a 13x10cm piece of white cardstock and write ‘pull here!’ on the right-hand side. Turn the tab over and lay it centrally onto the panel so it will be held in place with the double-sided tape. Trim any acetate visible at each side. Attach 3D foam pads around the edges, ensuring that it’s near the slits but not touching them.

Attach the panel to a 14.5cm-square white card blank. Remove the masking tape and slide the panel over. Stamp a sentiment onto a white circle, layer onto a slightly larger pink circle then attach to the base between the slits to finish.