Decorative Hello card

Using the blending sponge, add inks onto a piece of white cardstock. Die-cut the inked card using the panel die.

Place low-tack tape to the back of the die-cut and to a piece of white cardstock cut to the same size to create a hinge. Place the hinged card onto a piece of kitchen towel.

Cover the white piece with a piece of paper and spritz with water. Carefully lift the card onto your cutting plate and allow the white card to fold over onto the inked card.

Run through die-cutting machine with the top plate. Carefully peel back the card to reveal a faux stamped image of the die-cut.

Matt and layer a piece of white cardstock cut to 15x9cm onto a piece of black cardstock, leaving narrow borders, and affix onto the card front.

Cut the inked die-cut down as shown and add black cardstock to the reverse, under-cutting to hide any black edges. Add to the card front using 3D foam pads.

Create the sentiment using the label maker and add to the card front. Add crystal gems to finish.