Cosy wishes- birthday slider card

Stamp a ball of wool onto an 8x5cm white stitched rectangle and colour using markers. Stamp ‘Cozy wishes’ above the wool then layer the panel onto pink cardstock and attach to a slightly larger blue stitched rectangle.

Stamp a wool heart and basket onto white cardstock, colour using markers and cut out. Attach to the panel using 3D foam pads. This will be the sliding element for the design.

Follow the step-by-step guide below to create the slider mechanism.

Attach the panel to a 15x11.5cm white card blank. Remove the masking tape and slide the panel over. Stamp a sentiment onto white cardstock, trim and layer onto blue cardstock. Attach to the card blank, inside the slits as shown to finish.

Cut a 13.5x8cm piece of white cardstock for the pull-out tab. Write ‘pull here!’ near to the right side. Turn the tab over and lay it centrally onto the panel so it will be held in place with the double-sided tape. Trim any acetate that may be visible at each side. Adhere 3D foam pads around the edges ensuring they are near the slits but not touching them, as shown.