Vibrant Congrats Circles And Stars Card

Select four differently sized circle dies and die-cut the three largest from a white 13.5cm-square panel with the sentiment die in the centre.

Remove the dies and reposition the three circles, cutting again. Repeat until there are four circles each above and below the sentiment as shown.

Use repositionable tape to temporarily adhere the white panel to a 14cm-square of orange cardstock. For each circle cut, select the next smallest die, tape down over the aperture and cut.

Repeat until the second set of circle apertures is complete, positioning the dies centrally and off-centre for added dimension, then adhere together.

Use Aqua Flow markers to make inky patterns on a square of white cardstock which will show through the apertures, brushing randomly. Add 3D foam pads on the reverse of the die-cut panel and affix over the background.

Use the die-cut from the ‘congrats’ die as a guide and a pokey tool to position the tiny die-cuts. Add the ‘waste’ stars from the ‘you’re awesome’ card to finish.