Clean And Simple Layered Card To Send Hugs & Kisses

Apply drops of alcohol ink to a tub of water, dip a scrap of white cardstock onto the surface of the water to pick up the colour and dry with a heat tool.

Trim to measure 5x2½” and layer with an adhesive sheet measuring the same size.  Die-cut the panel using the large frame from the die set.

Die-cut five white sentiments and stack together securing each layer with PVA glue. Die-cut the small plaque sentiment from the top layer before adhering as shown.

Remove the sticky backing from the frame, adhere the sentiment topper in the centre and affix a white die-cut frame around the edge.

Coat the remaining exposed adhesive with micro beads and adhere the topper to a white panel measuring 5½x6¼” using 3D foam pads.

Pierce the edges of a white piece of white cardstock measuring 6x6¾”, layer the panel on top using 3D foam pads and adhere the card front to a white card blank measuring 6½”x7½” to finish.