1

Place a 5” square of white cardstock in the stamp positioning tool and the clean background stamp on it. Close the lid to pick up the stamp, add ink to the first diagonal lines and stamp. Mask off the stamped lines and ink up the next three lines then stamp using a different coloured ink.

2

Repeat this masking and stamping process until the entire panel is covered.

3

Use VersaMark ink to stamp the diagonal stripes onto a separate piece of a white card then heat-emboss using Midas Touch embossing powder.

4

Trim the background panel to 1/8” smaller than the card blank and adhere it to the card front. Cut a small tag, punch a hole at the top and tie twine through it.

5

Use a white sticker sheet and VersaFine Onyx Black ink to stamp the border stamps repeatedly until a whole sheet is covered in a pattern. Cut a strip to adhere to the card front.

6

Adhere the tag to the panel using 3D foam tape. Heat-emboss the sentiment in white, staple them together and adhere to the tag. Embellish with a black enamel heart.