Best wishes- partial die-cut diamond card
Cut a 18x21cm piece of white cardstock and score along the shorter edge at 5.5cm and 9cm. Fold and burnish the score lines in a Z shape.
Cut a 5.2x20.5cm piece of patterned paper, ink the edges and attach to the front panel, then trim a 8.7x20.5cm piece, ink the edges and attach to the back panel.
Secure the third smallest die diagonally on the centre of the first score line with low-tack tape. Secure the smallest die diagonally on the same line between the top of the card and the larger die.
Place the top cutting plate up to the score line and pass through die-cutting machine. Repeat with the small die between the bottom of the card and middle die.
Cut four small and two larger scalloped squares using the same dies and attach to either side of the partial die-cut. Die-cut flowers from yellow cardstock, shape and attach to the panels.
Die-cut the sentiment from orange cardstock and add to the back panel. Add pearls to the flowers and card as shown to finish.