Autumnal Best Wishes Card

Spray shaving foam larger than your cardstock onto a tray, smoothing the surface.

Add drops of different coloured inks onto the shaving foam.

Mix the inks by dragging a skewer over the foam in a swirling motion – but don’t mix them too much.

Press the cardstock into the shaving foam firmly into the foam so it is completely covered.

Pull the card back foam and scrape off most of the foam with a palette knife, then wipe the card with paper towel.

Die-cut several large and small leaves from the marbled pieces of card and attach to the card with 3D foam pads.

Trim 14x28cm of cream cardstock and score and fold at 7cm and 14cm, then layer a 14cm square of cream cardstock to make the easel base card. Trim two pieces of cream cardstock to 13cm square, matt onto brown cardstock and attach one to the easel base and one to the front.

Trim 2x13cm brown cardstock and wrap with ribbon, then attach with 3D foam tape to the easel base as a stopper and add bows to the card front as shown. Affix the leaves and sentiment with 3D foam pads and add gems to finish.