1

Cut a 20x14cm piece of Snow White cardstock, tape the large heart die in place on the right-hand side and die-cut. Die-cut two of the Honeyblossom Sprig from Snow White cardstock.

2

Apply adhesive around the edges of the aperture on the reverse, then place one of the flower die-cuts across the back of the aperture, making sure parts of the die-cut are affixed at the edges.

3

Snip into the second die-cut and place pieces over the gaps in the aperture, overlapping the edges of the aperture and the first die-cut. Trim off any excess at the edges.

4

Wrap two pieces of ribbon around the left side of the card front. Place 3D foam pads on the reverse of the aperture and small pieces of 3D foam pads on areas of the die-cuts.

5

Cut a piece of 20.5x14.5cm purple cardstock, attach the die-cut panel and adhere to the card front. Die-cut a sentiment from black cardstock and adhere, then tie on two pieces of ribbon and add gems to finish.